Author Topic: Preparing input splines  (Read 466 times)

Sandro

  • Administrator
  • Newbie
  • *****
  • Posts: 24
    • View Profile
Preparing input splines
« on: October 24, 2019, 02:58:50 pm »
Can I use splines that were directly imported from CAD software?

The Input splines for Cityscape Pro should be simple, with minimum required interpolation value. Vertex count should be as low as possible to speed up calculations and avoid problems. It is highly recommended to clean up splines that are directly imported from CAD software. In some cases it might make more sense to completely rebuild splines before using them in Cityscape Pro. The splines should NOT be self intersecting, when self intersection is detected, an error message will pop up with highlighted spline and. All splines should be closed, with an exception of Road Texture spline mask templates. When open spline is detected, an error message with highlighted vertices will pop up.
« Last Edit: October 28, 2019, 09:54:13 pm by San Dro »